 新聞中心產品分類 榮譽資質 友情鏈接 |
|
| 產 品 說 明 | 一．用途及主要特點 Application and main characteristic當含塵氣流以一定的速度由進氣管進入高效旋風除塵器時，氣流將由直線運動變為圓周運動。旋轉氣流的絕大部分沿器壁自圓筒體呈螺旋形向下，朝錐體流動。含塵氣體在旋轉過程中產生離心力，將密度大于氣體的合屑甩向器壁。合屑一旦與器壁接觸，便失去慣性力而靠入口速度的動能和向下的重力沿壁面下落，由排灰管進入集塵桶。旋轉下降的外旋氣流在到達錐體時，因圓錐形的收縮而向除塵器中心靠近。根據“旋轉矩”不變原理，其切向速度不斷提高，當氣流到達錐體下某一位置時，即以同樣的旋轉方向從旋風除塵器中部，由下而上繼續做螺旋形流動，即內旋氣流，***后凈化氣經排氣管排出旋風除塵器外。1、結構簡單，器身無運動動力部件，不需特殊的附屬設備，占地面積小、制造、安裝投資較少。2、操作、維護簡便，壓力損失中等，動力消耗不大，運轉、維護費用較低。3、操作彈性較大，性能穩定，不受含塵氣體的濃度、溫度限制，對于粉塵的物理性質無特殊要求。When the dust stream at a constant speed by a high intake manifold into the cyclone, the airflow by the circular motion into linear motion. Most of rotating air flow from the cylinder wall lanes along spiral downward, toward the cone flow. Dusty gas centrifugal force generated during rotation, the density is greater than the combined gas crumbs thrown to the wall. Close contact with the wall once the debris, but by force of inertia will lose inlet velocity kinetic energy and gravity along the wall falling down from the ash discharge pipe into the dust bucket. Fall outside the rotating rotary cone gas flow on the arrival, due to the conical shape of the filter close to the center of the contraction. According to "spin moment" invariance principle, and continuously improve its tangential velocity, when the air reaches the cone under a certain position, that is in the same direction of rotation from the middle of the cyclone, spiral flow bottom-up continue to do that pronation airflow, and finally purified gas through the exhaust pipe outside the cyclone.1.simple structure, no moving the body of the power unit, without special auxiliary equipment, small footprint, manufacture, install less investment.2,.operation, and maintenance is simple, medium pressure loss, less power consumption, operation, low maintenance costs.3. the operation is quite flexible, stable, free from dust concentration gas temperature limit, the physical properties of dust no special requirements.二．主要技術參數 main Technological Parameter| 名稱 | 單位 | 參數 | | 除塵率Removal rate | % | 91 | | 阻力損失Resistance loss | Pa | 900 | | 使用溫度范圍Operating temperature range | ℃ | 80~100 | | 過濾速度Filtration rate | m/s | 30 | | 出口含塵濃度Outlet dust concentration | g/Nm³ | 1 |
|
|
|
